Torx 25 Screwdriver
Plastic Disassembly Tool / Pry Bar
Simple Multimeter

On models with the short & thick mirror indicators, the light bulbs need to be replaced with orange non-Canbus LED bulbs, you can buy them here.

DRIVER'S SIDE:

1. Remove the two T25 screws behind the inner door handle that secure the door panel.

-------

2. Detach and unplug the tweeter using a plastic pry tool.

-------

3. Insert the pry tool at the bottom edge of the door and pry outwards until the door panel comes loose.
  Don't be afraid to use force. 

-------

4. Detach all connectors to the door panel and the wire for best possible access.

-------

5. Check that the Purple wire (pin 4) on the Green 6-pin connector has 12 volts when ignition position 2 is activated.

  *If the wire does not have 12v, you will need to find out which wire controls the door panel lighting.
  **If the car is equipped with illuminated inner door handles, use the blue/red wire that goes to that lighting.

-------

6. Take out the module and push one of it's wires together with pin 4 (Purple) from the back.
  Alternatively, together with the blue/red wire for the handle lighting. 

-------

7. Locate the large green connector that goes to the rearview mirror and push the module's second wire together with the blue/black wire from above.

-------

8. Check that it works.

-------

9. Zip-tie everything neatly and reassemble the door panel.

-------

PASSENGER SIDE:

1. Remove the door panel in the same way you removed the previous one.

-------

2. Check that the yellow wire (pin 1) on the blue connector has 12v when ignition position 2 is activated.

   *If the wire does not have 12v, you will need to find out which wire controls the door panel lighting.
   **If the car is equipped with illuminated inner door handles, use the blue/red wire that goes to that lighting.

-------

3. Take out the other module and push one of it's wires together with pin 1 (Yellow) from the back.
Alternatively, together with the blue/red wire for the handle lighting. 

-------

4. Locate the large green connector that goes to the sidemirror and push the module's second wire together with the blue/black wire from above.

-------

5. Check that it works

-------

6. Zip-tie everything neatly and reassemble the door panel.

-------

7. Snap a cool picture and post it on Instagram! Tag @RHTrading.se !