WHAT YOU NEED:

* Torx 25 Chisel
* Disassembly tool / Plastic pick
* Simple Multimeter

On models with the short & thick mirror turn signals, the bulb needs to be replaced with an orange Non-Canbus LED bulb, you can buy it here .

INSTRUCTIONS

DRIVER SIDE:

1. Loosen the two T25 screws behind the inner handle that secure the door side.

2. Click and disconnect the tweeter using a plastic spudger.

3. Place the breaking pick at the bottom edge of the door and break outwards until the door side comes loose .
Don't be afraid to take action.

4. Unclip all connectors to the door side and the wire for best possible access.

5. Check that the Purple wire (pin 4) on the Green 6-pin connector has 12 volts when ignition mode 2 is activated.
*If the cable does not have 12v, you will have to measure to find out which cable controls the door side lighting.
**If the car is equipped with illuminated interior handles, use the blue/red cable that goes to that lighting.

6. Take out the module and press one of the cables together with pin 4 (Purple) from the back.
Alternatively, together with blue/red cable for possible handle lighting.

7. Locate the large green connector that goes out to the rearview mirror and press the module's second cable together with the blue/black cable from above.

8. Check that it works.

9. Strap everything together neatly and reassemble the door side.


PASSENGER SIDE:

1. Remove the door panel in the same way you removed the previous one.

2. Check that the yellow cable (pin 1) on the blue connector has 12v when ignition mode 2 is activated.
*If the cable does not have 12v, you will have to measure to find out which cable controls the door side lighting.
**If the car is equipped with illuminated interior handles, use the blue/red cable that goes to that lighting.

3. Take out the module and press one of the cables together with pin 1 (Yellow) from the back.
Alternatively, connect with blue/red cable to the handle lighting.

4. Locate the large green connector that goes to the rearview mirror and press the module's second cable together with the blue/black cable from above.

5. Check that it works and

6. Strap everything together neatly and reassemble the door side.

7. Snap a cool picture and post it on Instagram! Tag @RHTrading.se!